Measurement

Basic Guidelines

Accurate measurements are essential in order for the blinds to properly fit the window opening.

Always use a steel tape measure.
Measure each window separately even if windows appear to be the same size.
For inside mounts, cloth will be approximately 1-1/4¨ narrower than window opening.
For outride mounts, cloth will cover window opening completely for maximum light blockage.

Measure the exact distance between inside surfaces of window frame at top, middle, bottom, and use the narrowest width. This will be your window opening measurement.
Measure height of window from inside surface at top of window down to sill, or to the point where fabric is to reach.

Product width (W): Order width -0.1¨

Product Height (H): Order Height

Window Depth (D) 2.65¨(6.5cm)

*when the depth of window frame is less than 3.34¨, the top valance will extend beyond the window frame.

Measure the width of the window opening and add 2-6¨foor maximum light blockage.
Measure the full height of the window from the top of the outer framer to the lower sill, and add 3-6¨to allow for complete coverage.
If the brackets are going to be mounted on the trim or framing above the window, measure from the trim's outside edge of from top to borrow.

Order Width (W): Window Width + 2-6¨

Order Height (H): window height + 3-6¨